Programming

Turn thumb wheel 1 to the "CRUISE" position: the cruise control mode is selected

Turn thumb wheel 1 to the "CRUISE" position: the cruise control mode is selected but is not switched on (PAUSE).

Set the programmed speed by accelerating to the required speed, then press button 2 or 3 (e.g.: 70 mph (110 km/h)).

You can then change the programmed speed using buttons 2 and 3:

- by + or - 1 mph (km/h) = short press,
- by + or - 5 mph (km/h) = long press,
- in steps of + or - 5 mph (km/h) = maintained press.

Switch off the cruise control by pressing button 4 : the screen confirms that it has been switched off (PAUSE).
Switch the cruise control back on by pressing button 4 again.

    See also:

    Tyre under-inflation detection
    System which automatically and continuously checks the pressure of the tyres while driving. Sensors fitted in each valve trigger a warning in the event of problem (speed above 12 mph (20 km/h)) ...

    Exterior welcome lighting
    The remote switching on of the lighting makes your approach to the vehicle easier in poor light. It is activated according to the level of light detected by the sunshine sensor. Switching on Pr ...

    Weights and towed loads (in kg) (2)
    * The weight of the braked trailer can be increased, within the GTW limit, if the GVW of the towing vehicle is reduced by an equal amount; warning, towing using a lightly loaded towing vehicle m ...