Cornering lighting

With dipped or main beams, this function makes use of the beam from a front foglamp

With dipped or main beams, this function makes use of the beam from a front foglamp to illuminate the inside of a bend, when the vehicle speed is below 25 mph (approximately 40 km/h) (urban driving, winding road, intersections, parking manouevres...).

with cornering lighting

with cornering lighting

without cornering lighting

without cornering lighting

Switching on

This function starts:

- when the corresponding direction indicator is switched on,
or
- from a certain angle of rotation of the steering wheel.

Switching off

The system does not operate:

- below a certain angle of rotation of the steering wheel,
- above 25 mph (40 km/h),
- when reverse gear is engaged

Programming

The system is activated or deactivated in the vehicle configuration menu.

The system is activated or deactivated in the vehicle configuration menu.

The system is activated by default.

    See also:

    Closing
    Take the stay out of its support slot. Clip the stay back into its housing. Lower the bonnet and release it at the end of its travel. Pull on the bonnet to check that it has latched correctly ...

    Access to the tools
    The tools are installed in the boot under the floor. To gain access to them: open the boot, lift the floor and remove it. remove the carrier box containing the tools. List of tools Al ...

    Removal
    To remove the mat on the driver's side: move the seat as far back as possible, unclip the fixings, remove the mat. Refitting To refit the mat on the driver's side: position the ...