Automatic lighting functions
Various automatic lighting functions are also available depending on options:
- guide-me-home lighting,
- cornering lighting,
- welcome lighting,
- daytime running lamps,
- automatic illumination of headlamps,
In some weather conditions (e.g. low temperature or humidity), the presence of misting on the internal surface of the glass of the headlamps and rear lamps is normal; it disappears after the lamps have been on for a few minutes.
Selection ring for main lighting mode
Turn the ring to position the symbol required facing the mark.
Model without AUTO lighting
Model with AUTO lighting
Stalk for switching headlamps
Pull the stalk to switch the lighting between dipped / main beam headlamps.
In the lighting off and sidelamps modes, the driver can switch on the main beam headlamps temporarily ("headlamp flash") by maintaining a pull on the stalk.
Displays
Illumination of the corresponding indicator lamp in the instrument panel confirms the lighting switched on.
Foglamps selection ring
The foglamps operate with dipped and main beam headlamps.
Rear foglamp only
- To switch it on, turn the ring forwards. When the lighting is switched off automatically (with AUTO model), the foglamp and the dipped beam headlamps will remain on.
- To switch it off, turn the ring rearwards.
Front foglamps and rear foglamp
Rotate and release the ring:
- forwards a first time to switch on the front foglamps,
- forwards a second time to switch on the rear foglamp,
- rearwards a first time to switch off the rear foglamp,
- rearwards a second time to switch of the front fog lamps.
When the headlamps switch off with automatic illumination of headlamps (AUTO model) or when the dipped beam headlamps are switched off manually, the foglamps and sidelamps remain on.
Turn the ring rearwards to switch off the foglamps, the sidelamps will then switch off.
In good or rainy weather, both day and night, the front foglamps and the rear foglamp are prohibited. In these situations, the power of their beams may dazzle other drivers. They should only be used in fog or snow.
In these weather conditions, it is your responsibility to switch on the foglamps and dipped beam headlamps manually as the sunshine sensor may detect sufficient light.
Do not forget to switch off the front foglamps and the rear foglamp when they are no longer necessary.
Switching off the lamps when the ignition is switched off
On switching off the ignition, all of the lamps turn off immediately, except for dipped beam if guide-me-home lighting is activated.
Switching on the lamps after the ignition is switched off
To reactivate the lighting control, rotate the ring to the "0" position - lamps off, then to the desired position. On opening the driver's door a temporary audible signal warns the driver that the lighting is on. The lamps, with the exception of the sidelamps, switch off automatically after a maximum duration of thirty minutes to prevent discharging of the battery.
See also:
Cruise control
System which automatically maintains the speed of the vehicle at the value programmed
by the driver, without any action on the accelerator pedal.
The cruise control is switched on manually: it requ ...
Stopping the vehicle
Before switching off the engine, you can choose to:
- move to position N to engage neutral,
- leave the gear engaged; in this case, it will not be possible to move the vehicle.
In both cases, you m ...
Weights and towed loads (in kg) (2)
* The weight of the braked trailer can be increased, within the GTW limit, if
the GVW of the towing vehicle is reduced by an equal amount; warning, towing using
a lightly loaded towing vehicle m ...