Programming

Turn thumb wheel 1 to the "LIMIT" position: the speed limiter mode is selected

Turn thumb wheel 1 to the "LIMIT" position: the speed limiter mode is selected but is not switched on (PAUSE).

You do not have to switch the speed limiter on in order to set the speed.

Set the speed value by pressing button 2 or 3 (e.g.: 55 mph (90 km/h)). You can then change the programmed speed using buttons 2 and 3:

- by + or - 1 mph (km/h) = short press,
- by + or - 5 mph (km/h) = long press,
- in steps of + or - 5 mph (km/h) = maintained press.

  • Switch the speed limiter on by pressing button 4 .
  • Switch the speed limiter off by pressing button 4: the display confirms that it has been switched off (PAUSE).
  • Switch the speed limiter back on by pressing button 4 again.
    See also:

    Operating fault
    In the event of a malfunction of the system, when reverse gear is engaged this warning lamp is displayed in the instrument panel and/or a message appears in the screen, accompanied by an audible ...

    Direction indicators
    Lower the lighting control stalk fully when moving to the left. Raise the lighting control stalk fully when moving to the right. If you forget to cancel the direction indicators for more tha ...

    Memorising speeds
    This memorisation of speeds applies to both the speed limiter and the cruise control. You can memorise up to 5 speed settings in the system. By default, a few speeds are already memorised. ...