Locking the vehicle with exterior perimeter monitoring only

Deactivate the interior volumetric monitoring to avoid unwanted triggering of the alarm in certain cases such as:

- leaving a pet in the vehicle,
- leaving a window partially open,
- washing your vehicle.

Deactivation of the interior volumetric monitoring

Switch off the ignition.

Switch off the ignition.
Within ten seconds, press the button until the indicator lamp is on continuously.

Get out of the vehicle.

Get out of the vehicle.
Press the locking button on the remote control immediately.

The exterior perimeter monitoring alone is activated: the indicator lamp in the button flashes once per second.

To be effective, this deactivation must on the remote control. be carried out each time the ignition is switched off.

Reactivation of the interior volumetric monitoring

button on the remote control to deactivate the exterior perimeter monitoring.Press the unlocking button on the remote control to deactivate the exterior perimeter monitoring.

 

on the remote control to activate all the monitoring functions.Press the locking button on the remote control to activate all the monitoring functions.

 

the button again flashes once per second.The indicator lamp in the button again flashes once per second.

 

    See also:

    Coolant temperature indicator
    With the engine running, when the needle is: - in zone A , the temperature is correct, - in zone B , the temperature is too high; the max temperature warning lamp 1 and the central STOP warning ...

    Moving off
    Select position N. Press the brake pedal down fully. Start the engine. N appears in the instrument panel screen. N flashes in the instrument panel, accompanied by an audible signal and a ...

    Rear screen demist - defrost
    The control button is located on the heating or air conditioning system control panel. Switching on The rear screen demisting/defrosting can only operate when the engine is running. Press this ...